Entertain Your Guests Comfortably

« Back to Home

Preserve Your Hot Water Supply And Maintain Your New Electric Heater

Posted on

If your electric hot water heater is stored inside of a wooden utility shed that is next to your residence, a lack of insulation can result in water freezing inside of the lines. Take the time to insulate the shed and water lines and maintain the unit as a whole so that hot water does not freeze and the unit does not malfunction when the temperature begins to plummet.

Complete Insulation And Repair Steps

Purchase some thermal sleeves, caulking, and a caulk tool. You will need a utility knife or sharp pair of scissors and a measuring tape when fitting each water line with a thermal covering. The lines that are extending from the hot water heater and the plumbing pieces that are attached to the main water valve need to be covered with a uniform layer of protection.

A thermal sleeve is a material that will easily slip around plumbing pieces. After measuring and cutting pieces, use several strips of tape to secure the thermal coverings to each line.

Don't overlook the condition of the wooden structure that the heater is stored inside of. If the structure hasn't been insulated, cold air will forcefully enter through cracks when it is cold and windy. Caulk can be used to seal narrow cracks, but anything that is larger should be inspected and fixed by a qualified repair person. 

Take Care Of The Heater And Report Problems

When you purchased the hot water heater, you were likely supplied with an owner's manual that describes each of the unit's components and provides a list of troubleshooting techniques. The installer of the unit should have gone over some of the basic fundamentals associated with keeping the unit maintained.

The main things to be concerned about are keeping the unit's exterior dry and clean and avoiding the placement of items next to the unit. It is also a good idea to keep the unit's thermostat at the same temperature. If the water in your home is too hot or too cold, however, simply adjusting the thermostat won't cause any harm.

If your unit came with a drip pan, this pan is used to collect condensation that is emitted from the unit. Check the pan periodically and clean it and empty the accumulated water outdoors. Be aware of any odd sounds that the unit makes or a noticeable shortage of hot water and contact the manufacturer of the unit or the person who installed it to assist with correcting the problem.

For more information, reach out to a company like First Class Plumbing of Florida Inc.


Share